







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
See the difference
Before
After
Before
After
Before
AfterCabinet Refacing vs. Replacement in Cutler Bay, FL: Which One Fits Your Kitchen?
Choose replacement if your original cabinet box fails a moisture or squareness check; choose refacing only if the existing box is dry, square, and still holding screws. Cabinet refacing is the right answer about half the time in a Cutler Bay kitchen, and the wrong answer the other half. The difference isn’t your taste or your budget. It’s whether the original box is still dry and square enough to hold a new veneer and door for ten years. Call Bradford Remodeling Co Cutler Bay at (833) 620-5491 for a free written assessment before you decide.


Why Cutler Bay Kitchens Land in This Decision So Often
Most of Cutler Bay’s housing went up between the 1980s and 2000s, on former farmland and pine rockland west of US 1. That means a large share of the kitchens we open up still have their first set of cabinets in them – particleboard boxes that have been pulling in summer humidity, salt air, and the occasional storm-surge damp near the bayfront blocks around Black Point and Saga Bay for going on 30-plus years.
Particleboard doesn’t fail all at once. It swells slowly, loses density around fasteners, and delaminates along the edges first. A door hung on a swollen box reads fine in month one. By month eight, the gaps open and the hinges start pulling. For builders in Cutler Bay, that box condition is the single variable that decides whether refacing is a smart investment or a callback waiting to happen inside 18 months.
The Three-Point Box Inspection We Run Before Recommending Anything
Before we quote either number, we inspect the existing box. This is the part most comparisons skip. A refacing job priced without it is a guess.
- Moisture meter reading on each base cabinet floor. Anything above 16% moisture content and the box is a replacement candidate. The floor pan is where spills, leaks, and condensation collect, and it tells you more about the substrate than the box face ever will.
- Face frame squareness check with a framing square. A racked box produces door-gap failures within a year, no matter how good the new door is. If the frame is out of square, refacing just hides the problem.
- Screw-pull test at the hinge block. We seat a screw and load it. If the particleboard strips instead of holding, the box is done. New door weight will finish the job on its own.
Our technicians have up to 22 years of experience running this exact check, and we document the result in writing, with photos, before a single piece of work is scoped. If the boxes pass, you get the refacing price. If they don’t, you get the replacement number. No undisclosed condition discovered after demo, no number that moves at the door.

Cabinet Refacing vs. Replacement Cost in Cutler Bay
For a 1980s ranch home with 15 to 20 linear feet of cabinets on the counter run – the common size in these subdivisions – here’s what the two paths actually run in this market.
| Scope | Typical Cutler Bay Range |
|---|---|
| Cabinet refacing (new veneer, doors, drawer fronts) | $4,500 – $9,000 |
| Full cabinet replacement (KraftMaid or Wellborn) | $14,000 – $28,000 |
| Cabinet installation alone, new boxes | $4,000 – $13,000 |
| Full kitchen remodel, standard scope | $14,000 – $45,000 |
| New countertops (Cambria or Caesarstone) | $2,000 – $6,500 |
Read those as cost per year of reliable service life, not sticker price. Refacing at $6,000 that lasts 10 years costs $600 a year. Refacing at $6,000 that fails in 2 years because the box was wet costs $3,000 a year, plus the replacement you still have to buy. Replacement at $22,000 that lasts 25 years costs $880 a year. The cheapest-looking path is often the most expensive per year once the box condition is factored in.
What Refacing a Damp Box Actually Does to Your Kitchen
Here’s the risk nobody puts a number on. A new door and drawer front are heavier than the originals, and new hardware adds more load at the hinge block. On a swollen box, that added weight accelerates the delamination already in progress. We’ve seen it play out the same way in Cutler Bay: the homeowner pays for refacing, then pays again for replacement within three years – spending more than a straight replacement would have cost up front. That’s money spent twice for one kitchen.

If we recommend replacement, it’s because the inspection says so, not because the ticket is bigger. The written price is what protects both sides of that call, and it’s the same discipline we bring to every stage of Kitchen Remodeling in Cutler Bay.
Common Scenarios We See in Cutler Bay Kitchens
The 1980s subdivision ranch, original cabinets never touched
This is the most common call. Particleboard boxes, 30 years of humidity, doors sagging at the corners. We run the three-point check. About half pass and reface cleanly; the other half get the replacement number. You’ll know which one you are within an hour.
The gated community kitchen with resale disclosure on the horizon
In communities like Saga Bay and Old Cutler Bay, replacing with documented brands such as KraftMaid or Wellborn lets you record the brand, door style, and finish code for HOA records. If the community ever reviews interior standard specifications, you have a paper trail. Refacing doesn’t give you that same documentation.
The remodel already underway after a storm claim
When a kitchen is already torn open for other work, replacement often pencils out because the labor is shared. Refacing is cheapest when the kitchen is intact, not when it’s already stripped.
How to Decide, in Plain Terms
- Get the box inspected before either option is priced. A quote without an inspection is a guess.
- Treat moisture above 16% as a hard stop on refacing.
- Compare cost per year of reliable service, not sticker price.
- Ask for the inspection result in writing, with photos, before work is scoped.
FAQs About Cabinet Refacing vs. Replacement in Cutler Bay
Refacing is cheaper up front, typically $4,500 to $9,000 versus $14,000 to $28,000 for KraftMaid or Wellborn replacement on a typical 15 to 20 foot run. But if the original box is damp or out of square, refacing is the more expensive path because you’ll likely pay for both. Call (833) 620-5491 for a free estimate – we’ll check the box first.
They can be refaced if the box floor reads under 16% moisture content, the face frame is square, and the hinge block holds a loaded screw. That’s the test that decides it. Call (833) 620-5491 and we’ll run the three-point check in person and document the result for you.
Yes – call (833) 620-5491 and we’ll schedule a free, no-pressure assessment. We answer live, day or night, and the written price comes before any work starts.
If the work fails within the guarantee period, we come back and correct it at no charge under the 365-Day Done Right Promise. You get the written guarantee in your hand at job close, along with a clean site and a documented scope. Call (833) 620-5491 for a free estimate.
Ready to Settle It?
If you’d rather have it looked at, Bradford Remodeling Co Cutler Bay offers a no-pressure assessment in Cutler Bay. We’ll inspect the boxes, put the number in writing, and let the condition of your cabinets decide the recommendation. Call (833) 620-5491 for a free estimate.
Written by the team at Bradford Remodeling Co Cutler Bay, serving Cutler Bay, FL.


